Low-temperature growth of thick intrinsic and ultrathin phosphorous or boron-doped microcrystalline silicon films: Optimum crystalline fractions for solar cell applications

The growth kinetics and optoelectronic properties of intrinsic and doped microcrystalline silicon (μc-Si:H) films deposited at low temperature have been studied combining in situ and ex situ techniques. High deposition rates and preferential crystallographic orientation for undoped films are obtained at high pressure. X-ray and Raman measurements indicate that for fixed plasma conditions the size of the crystallites decreases with the deposition temperature. Kinetic ellipsometry measurements performed during the growth of p-(μc-Si:H) on transparent conducting oxide substrates display a remarkable stability of zinc oxide, while tin oxide is reduced at 200°C but stable at 150°C. In situ ellipsometry, conductivity and Kelvin probe measurements show that there is an optimum crystalline fraction for both phosphorous- and boron-doped layers. Moreover, the incorporation of p-(μc-Si:H) layers produced at 150°C in μc-Si:H solar cells shows that the higher the crystalline fraction of the p-layer the better the performance of the solar cell. On the contrary, the optimum crystalline fraction of the p-layer is around 30% when hydrogenated amorphous silicon (a-Si:H) is used as the intrinsic layer of p-i-n solar cells. This is supported by in situ Kelvin probe measurements which show a saturation in the contact potential of the doped layers just above the percolation threshold. In situ Kelvin probe measurements also reveal that the screening length in μc-Si:H is much higher than in a-Si:H, in good agreement with the good collection of microcrystalline solar cells.