Upper limb involuntary tremor reduction using cantilever beam TMDs

Tuned mass dampers (TMDs) are proposed as a solution to reduce the involuntary tremor at the upper limb of a patient with postural tremor. The upper limb is modeled as a three-degrees-of-freedom rotating system in the vertical plane, with a flexion-extension motion at the joints. The measured extensor carpi radialis signal of a patient is used to excite the dynamic model. We propose a numerical methodology to optimize the parameters of the TMDs in the frequency domain combined with the response in the time domain. The objective function for the optimization of the dynamic problem is the maximum angular displacement of the wrist joint. The optimal stiffness and damping of the TMDs are obtained by satisfying the minimization of the selected objective function. The considered passive absorber is a cantilever beam–like TMD, whose length, beam cross-sectional diameter, and mass position reflect its stiffness for a chosen additional mass. A parametric study of the TMD is conducted to evaluate the effect of the TMD position along the hand segment, the number of TMDs, and the total mass of TMDs. The sensitivity of the TMD to a decrease of its modal damping ratio is studied to meet the range of stainless steel. TMDs are manufactured using stainless steel beams of the same length (9.1 cm) and cross-sectional diameter (0.79 mm), for which the mass (14.13 g) position is adjusted to match the optimal frequency. Three TMDs holding a mass of 14.13 g each cause 89% reduction in the wrist joint angular displacement.